Circle Area
Enter a radius and calculate the area of a circle.
About this tool
The area is π times the radius squared. A radius of zero or less stops the calculation instead of being treated as a point.
The diagram is a sketch of the same radius. It is not a scale drawing.
How to use it
- Enter the radius. The field starts at 1.
- Choose Calculate. The diagram uses that radius.
- Copy the area. A radius that is not greater than zero is rejected.
Limitations
- The radius must be greater than zero. π is Math.PI in this browser.
- Units are yours. A radius in centimetres gives an area in square centimetres.
Pi times radius squared, area only
The single measurement
The only input is the radius. It must be greater than zero. The area is π multiplied by the radius multiplied by the radius again. The panel prints that area and the diagram draws a circle scaled from the same radius. Circumference is not printed. Diameter is not a separate box, so a diameter must be halved before you type it.
Radius three
π × 3 × 3 = 9π, which is about 28.2743338823 when the decimal expansion is shown. Doubling the radius does not double the area. Radius 6 would multiply the area by four, because the radius is squared. A radius of 1 prints an area equal to π itself. The formatter used for the caption and the text keeps a bounded number of fractional digits, so the last place is a rounded view of the floating-point product, not a new truncation of π chosen by you.
Zero, negatives, and the missing circumference
A radius of zero is rejected. A negative radius is rejected. There is no annulus mode that would subtract an inner disk from an outer disk. If you need a ring, compute two areas and subtract them elsewhere. The diagram is the disk’s outline for the area you just computed. It does not mark an arc length. People who type a diameter into the radius box get an area four times too large and no warning, because a positive number is a legal radius. Label the quantity before you type it.
Scaling and a sector you must finish elsewhere
Tripling the radius multiplies the area by nine. The decimal you see is π times that square, rounded in the display, so two radii that differ only past the printed places can collapse to the same text. A sector of the disk is not a mode. If you know the central angle in degrees, the sector’s area is this full area times the angle divided by 360, and you have to apply that fraction after you leave the page. An angle of 180 would be half the disk. The page will not take the angle, and it will not take an arc length in place of the radius.
Privacy
Your input is processed in your browser and is not uploaded to UtilChain. File names, text, and results are not sent to analytics.

