Cylinder Volume
Calculate the volume of a right circular cylinder from its radius and height.
About this tool
The volume is π × r² × h. The two circular ends are the same size, and the side is perpendicular to them.
A zero or negative length is rejected. The diagram sketches the radius and height you entered.
How to use it
- Enter the radius and the height.
- Calculate. The diagram uses those lengths.
- Copy the volume. A non-positive radius or height is rejected.
Limitations
- The formula is π times radius squared times height. It is a right circular cylinder, not a tube with a hollow core.
- Units follow the lengths you enter.
Pi r squared times the height
Radius and height only
Both the radius and the height must be greater than zero. The volume is π × radius × radius × height, the area of the circular end times how far that disk is extruded. The panel prints the volume. It does not print lateral area, total surface area, or the circumference of the rim.
Radius two, height five
The end area is π × 4. Times height 5, the volume is 20π, about 62.8318530718. Radius 1 and height 1 print a volume of π. Doubling the height doubles the volume. Doubling the radius multiplies the volume by four, because the radius is squared and the height is not.
Rejected signs, and the surface you might have wanted
A zero radius, a zero height, or a negative on either box is rejected. There is no hollow-tube mode that would subtract an inner cylinder. If the solid is a tube, run the formula twice and subtract. The diagram shows a cylinder scaled from the radius and the height you accepted. It does not unfold a net. People sometimes type the diameter in the radius box. The volume then comes out four times too large, and the only clue is your own labeling, because any positive radius is accepted.
Comparing with a cone and a box
A cone with the same radius and the same height has one third of this volume. Radius 2 and height 5 therefore correspond to a cone of about 20.94395, one third of 20π. This page will not print that companion figure. A square prism with side length equal to the diameter would be a different solid. Diameter 4 and height 5 give a box of 4 × 4 × 5 = 80, while the cylinder is 20π, about 62.83, which fits inside that box. The comparison is a sanity check you do by hand. The cylinder form only multiplies π by the squared radius and the height. Oblique cylinders are outside the assumption. The height is taken as perpendicular to the circular ends.
Privacy
Your input is processed in your browser and is not uploaded to UtilChain. File names, text, and results are not sent to analytics.

