Scientific Notation

Write a finite number as a coefficient from 1 up to 10 times a power of 10.

Use this tool

Result

The result appears in this panel after you run the tool.

About this tool

The page scales the number by powers of ten until the coefficient sits in that range, and it reports the exponent with it.

It does not evaluate an expression. Use a calculator when you still need to compute the number.

How to use it

  1. Enter a finite number.
  2. Calculate.
  3. Read the coefficient and the power of 10. Zero is shown as zero.

Limitations

Coefficient times ten to a floor exponent

How the split is chosen

For a nonzero finite input, the exponent is the floor of the base-10 logarithm of the absolute value. The coefficient is the original number divided by ten to that exponent, so the coefficient’s absolute value lands in the half-open interval from 1 up to 10. The panel prints the coefficient, a times sign, and 10^ followed by the exponent. Zero is special-cased as 0 × 10^0, because the logarithm of zero is not defined.

Two concrete splits

24680 has floor(log10(24680)) = 4, and 24680 / 10^4 = 2.468, so the panel reads 2.468 × 10^4. A negative fraction works the same way on the absolute value, with the sign kept on the coefficient. −0.0042 has floor(log10(0.0042)) = −3, and −0.0042 / 10^−3 = −4.2, so the panel reads -4.2 × 10^-3. The coefficient is formatted with at most ten fractional digits. The exponent is an integer written without grouping separators.

What this normalization is not

It does not shift to engineering notation, where the exponent would be a multiple of three. 24680 stays at exponent 4, not at 24.68 × 10^3. It does not accept a pair of boxes for “mantissa and exponent” and then multiply them. You type one decimal, and the page only rewrites it. Numbers that are not finite decimals are refused by the parser. A result is not a rounded significant-figure exercise beyond the ten-digit display cap. Binary values that have no short decimal, such as many repeating fractions, can show a long coefficient even though the exponent is exact for that floating-point input. There is no separate significant-digit control.

Checking the split by scaling

Multiply the printed coefficient by ten raised to the printed exponent and you should land back on the input, up to display rounding. For 2.468 × 10^4 the product is 24680. For -4.2 × 10^-3 the product is -0.0042. If a coefficient’s absolute value is below 1 or at least 10, the split was misread, because this page’s floor rule forbids that range except for the special case of zero. Scientific notation here is a rewrite of one number. It is not a calculator for adding two numbers that are already written as coefficients and exponents.

Privacy

Your input is processed in your browser and is not uploaded to UtilChain. File names, text, and results are not sent to analytics.