Timer

Set a duration and start it.

Use this tool

Result

The result appears in this panel after you run the tool.

About this tool

The readout is the time left. Pausing keeps the elapsed amount.

There is no alarm sound and no background notification.

How to use it

  1. Open this page and provide the input it asks for.
  2. Set the options that are visible, then use Start.
  3. Read the result in the panel. Copy it or download it when a file is offered. The input stays in this browser.

Limitations

Start begins the full length again

Where the length comes from

The length is the minutes field times 60000 plus the seconds field times 1000. Blank fields count as zero. The readout is that length minus the time the page has been running since the latest start, and it never goes below zero. At zero it stays 0:00:00. There is no alarm, no sound, and no notice beyond the digits. Redraws happen about every 200 milliseconds, and fractional seconds are cut off, so you see whole seconds.

This length is not an instant on the calendar. It does not consult daylight-saving rules, because it never converts a wall clock into a timestamp. Ten minutes is 600000 milliseconds here even if those ten minutes contain a transition in your zone. That is intentional. A kitchen timer should not become nine minutes because the civil clock skipped an hour. If you instead need the time remaining until a date, use the countdown, which subtracts now from an instant and will notice a short or long civil day.

Pause holds the digits, and the next start does not continue them

While running, elapsed time accumulates from the monotonic clock. Pause stops the refresh and keeps the digits you see. The next start clears that accumulation before running again. The readout jumps back to the full minutes and seconds you configured, then counts down from there. Pause is a way to freeze the picture. It is not a resume of the leftover seconds. If you wanted the leftover to continue, this button will disappoint you. Change the minutes or seconds first if the full length should be different on the next start. The fields are read when the display renders, so an edit while running changes the target length under the same accumulation.

Reset halts the run, zeroes the stored elapsed time, and empties the output. Hours are not a separate field. Put a long interval in as minutes. The printer can show hour digits once the total reaches 3600 seconds, because it formats total seconds as H:MM:SS without a 24-hour wrap. Nothing on this page is a Unix timestamp, and nothing on it is a weekday. Copy the digits if you need them after you leave. The running state does not survive navigation.

Privacy

Your input is processed in your browser and is not uploaded to UtilChain. File names, text, and results are not sent to analytics.