Audio Crop
Set a start and an end. The download keeps only the samples inside that span.
About this tool
The result is 16-bit PCM. The sample rate stays as it was.
How to use it
- Choose a WAV, AIFF, or MP3.
- Set the start and end in seconds. The end has to fall inside the file.
- Download the WAV, or continue with volume, a fade, or another edit.
Limitations
- The cut is a hard sample boundary. This page does not fade the edges of the crop.
Frames kept between two times
Where the cut lands
Start and end are seconds, not beats and not bars. Each is multiplied by the sample rate and rounded to a frame. At 44100 Hz, 0.40 seconds is frame 17640 and 1.25 seconds is frame 55125, so the copy is 37485 frames long. Stereo stores two samples for every one of those frames. A start before zero, an end past the last frame, or an end that is not after the start is rejected before any file is written. The player under the result uses the new WAV, so you can hear the span without leaving the page.
What is copied
The samples inside the span are copied in order. Nothing outside it is mixed in, and the edges are not ramped. If the sample just before the start was a large positive value and the first kept sample is a large negative value, a speaker can click. That click is the jump. Fade In and Fade Out are separate pages for when you want a ramp after the cut. The rate, the channel count, and the bit depth of the download are the working format of this site: 16-bit little-endian PCM in a RIFF WAVE chunk. An MP3 is measured from its frame headers first. The page decodes only the frames that cover the start and end, plus a short run of earlier frames so the bit reservoir still has the bytes those frames borrow. The kept samples are the requested seconds, written as WAV. The download is not a sliced MP3.
Length and handoff
A decoded edit is refused when the float samples would pass 65.9 MB, which is three minutes of 48 kHz stereo. A mono file or a lower rate can run longer, because the check is that byte size. The message names the seconds, the rate, the channel count, and the megabytes. A 16-bit PCM WAV is cropped by copying frames from the data chunk, so a long file can still yield a short span. That copy is limited by the same 65.9 MB budget for the slice plus the new file, and the whole file is not turned into floating-point samples. LIST and cue chunks are omitted from the new file. An MP3 crop decodes the selected range. AIFF is still decoded in full, and that decode has to fit the same budget. The next-step list sees a WAV. Volume Change, Peak Normalization, and the filters can take that WAV. WAV to MP3 is a format step, not another crop. Running crop twice means choosing a range inside the already shortened file. The second range is not added to the first. If you needed 0.40 through 1.25 and then only the first half of that, set the second end to half of the new duration, which is about 0.425 seconds, not 0.825.
Privacy
Your input is processed in your browser and is not uploaded to UtilChain. File names, text, and results are not sent to analytics.

