Volume Change

Type a gain in decibels. Positive values get louder until the samples hit the clamp.

Use this tool

Drop a file here, or use the picker. The file type is checked from its contents.

Result

The result appears in this panel after you run the tool.

About this tool

Gain is applied to every channel. Zero decibels is unity.

How to use it

  1. Choose a WAV, AIFF, or MP3.
  2. Set the gain. Zero leaves the samples unchanged. Six decibels is about twice the amplitude.
  3. Download the WAV. You can run this page again on the result because the change is marked repeatable.

Limitations

One decibel gain for every sample

From decibels to a multiplier

The box is a decibel change, not a percentage and not a mixer fader law. The multiplier is ten raised to the power of the decibel value divided by twenty. Six decibels is about 1.995, so a sample of 0.2 becomes about 0.4. Negative six decibels is about 0.501, so that same sample becomes about 0.1. Zero is a multiplier of one, which is why a zero gain download matches the source aside from the 16-bit requantization. Twenty-four decibels up is about 15.85 times the amplitude. Twenty-four down is about 0.063. Values outside that box are not offered, because a larger boost is almost always just a clamp.

The clamp

Each product is forced back into the range from negative one to one before it is stored. A source that already peaks at 0.8, boosted by six decibels, wants to peak near 1.6 and is stored as 1. The top of the wave becomes a flat line. That flat line is distortion, and a later cut in gain cannot restore the rounded peak, because the extra height was discarded. If you need the file louder without flattening, Peak Normalization stops at a target under full scale, and Audio Compressor reduces only the part of the wave that crosses a threshold. This page applies one gain to the entire duration, including silence, so the noise floor rises and falls with the program.

Repeating the step

The catalog marks this change as repeatable, so a chain may offer it again after another edit. Two passes add in decibels: plus three and then plus three is the same multiplier as plus six, until a clamp on the first pass throws information away. The second pass then scales the already flattened wave. Listen to the preview after the first pass before you stack another boost. MP3 sources are decoded, scaled, and written as WAV. The MP3 bitrate does not carry through. If the destination has to be MP3, use WAV to MP3 after the gain, and expect the encoder to add its own noise on top of any clamp you already created.

Privacy

Your input is processed in your browser and is not uploaded to UtilChain. File names, text, and results are not sent to analytics.