Peak Normalization

Set a target peak in decibels below full scale. The whole clip scales together.

Use this tool

Drop a file here, or use the picker. The file type is checked from its contents.

Result

The result appears in this panel after you run the tool.

About this tool

The loudest absolute sample sets one gain for every sample.

How to use it

  1. Choose a WAV, AIFF, or MP3.
  2. Set the target. Negative one leaves a little headroom under full scale.
  3. Download the WAV. Quiet passages rise by the same amount as the peak.

Limitations

One gain taken from the loudest sample

Finding the peak

Every sample in every channel is inspected. The peak is the largest absolute value. A file that reaches 0.5 on the left and 0.2 on the right has a peak of 0.5. Silence, a peak of zero, is left unchanged, because there is no finite gain that would create a peak from nothing. The target is a decibel level relative to a full-scale sample of one. Negative one decibel is about 0.891. The gain is that target divided by the measured peak. A peak of 0.5 heading for negative one decibel is multiplied by about 1.78. A peak of 0.99 heading for negative one is multiplied by less than one, so an already hot file gets slightly quieter. That is still normalization. It is not only a boost.

What does not move independently

The noise floor, the breaths, and the loudest hit all move by the same multiplier. If the hit was much louder than the speech, the speech stays much quieter than the hit. A compressor changes that relationship. This page does not. It also does not know about inter-sample peaks. A reconstructed analog wave can stick out past the samples even when every stored sample is under the target. True-peak limiting is not implemented. A target of zero places the loudest sample at full scale. Any later boost, including an MP3 encoder that overshoots, can clip. Negative one is the default for that reason.

Not a loudness page

Broadcast and podcast specs often ask for integrated loudness in LUFS plus a true-peak cap. Those meters look at perception over time, not at one sample. This site does not ship that meter, and this page will not pretend a peak match is a loudness match. Two clips normalized here to the same peak can still sound very different if one is a dense mix and the other is a single hit with a long tail. Use the number as a headroom decision. Audio Properties can show the peak in decibels before you choose a target, so you can see how far the file will move.

Privacy

Your input is processed in your browser and is not uploaded to UtilChain. File names, text, and results are not sent to analytics.